Nail it in place with two nails one.
Nailing down roof flashing.
Then set the piece down.
Make sure that the roof is completely clean.
Ensure it sits flat and extends at least 8 inches above the shingles.
Fasten drip edge on eaves with galvanized nails and a hammer about 12 inches.
Bend it back so that it overlaps the corner flashing.
The nails should start.
How to nail down roll roofing step 1.
Nail metal drip edge flashing which bends over the roof and down the edge of the facing board on all roof edges.
Aluminum gray roof flashing model 12953 9 89 9.
These solid copper nails are the type recommended for use with many major brands of tile and slate roofing and are the most compatible nails for use with copper flashing the full 3 8 head gives good bearing pressure on roofing and flashing material.
Recaulk the joints between the roof and the flashing.
White adjustable m vent roofing vent sbs flashing for low slope roofs model 4m23920mw 102 71 102 71.
Install the drip edge by fitting it on the roof eave pushing it tightly against the edge of the plywood and nailing or screwing it down.
Space the fasteners by about 12 inches.
How to install step flashing with a wall corner step three.
Diamond point makes driving easy.
Fasten loose nails and cover exposed nail heads with roofing cement.
Ring shank holds tight.
Cover the valley of the roof.
Make corner flashing from step flashing.
Oatey no calk 3 in.
Hammer one nail to the.
Nail down the 18 inch roll roofing sheet that it is covering the valley.
Many roofers use pneumatic nail guns to nail down the shingles.
Once you ve shingled up to the sidewall cut a piece of step flashing at a 45ยบ angle from the outside corner to the bent seam.
Set your store to see local availability add to cart.
Bend it down and back to sit flat on the corner.
It s much easier to reseal the flashing than it is to patch a water stained wall or ceiling.
The valley of the roof is the point on the roof where the two sides meet.
Renew flashing seals by chipping out old caulking and mortar along the edges of the flashing.
When the nails are overdriven the heads of the nails punch right through the mat of the shingle.
Then sink two nails in the wall near the top one on each face.
Overlap two pieces of flashing that meet end to end by at least 1 inch.
